Pantry Potion: Stained Glass Jars

Officially my new favorite DIY project, these stained glass jars are easy, cheap and full of opportunities to personalize.  I'm in the middle of making a new Halloween prop that calls for a lantern type jar.  I wanted something a little different than my Witch's Jars, something a bit more Enchanted Forest Fairy and less bloody & muck.  YouTube proffered a fantastic & short how-to on staining glass that seemed perfect and everything you need is likely already in your pantry.

Here's what you need:
Glass jars - Mason or rinsed spaghetti, salsa, jelly, etc.  Use Goo Gone to remove any label glue
Modge Podge
Food Coloring
(Bake at 215° for 1-2 hours, until all glue is clear)

I followed the YouTube instructions for my first 2 jars and while I think the overall, consistent color is cool (see the green jars below), it wasn't quite right for my project.   Rather than pre-mixing the food coloring & Modge Podge, I decided to coat the jar with MP first and then add drops of food coloring, working the color around by rolling and tipping the jar.  I also upped the cooking temp to 215° as I felt it cooked a little faster without "burning" the glue.

So far the results are killer.  I think it could still use a bit of tweaking, getting the glue to food coloring ratio just right changes the results.  For now though, I'm in love with my new Fairy Jars.

***Bloody Valentine Votive seekers, scroll down to the end of the post for more details!***

Tips:

• The food coloring will almost run right over the Modge Podge at first, different densities and all.  Eventually they will combine, something you may or may not desire.  The more you work the MP around, the more it will mix.  Too many colors & swirling, the more muddled it will get.  Get it just right and combine two complimentary colors for a fabulous 3 color finish (ie., red & yellow swirls with orange, red & blue with purple, etc.)

• Start with the lightest color.  The darker colors dominate and you don't need nearly as much so add a little at a time.

• Try to avoid excess Modge Podge.  It collects in the bottom and takes forever to dry.  Adding the food coloring adds liquid so you can go a bit light on the MP, even leaving blank areas.  Once you add to food coloring,  you'll have enough to cover the blanks.  (Or leave them clear, up to you.)

• If you do wind up with a pool of Modge Podge, don't despair! You can coat the jar with it again to expedite the drying process.  Using hot pads, take the jar out of the oven and tilt it slightly to one side.  Tilt & roll the jar around, working the VERY HOT, lava-like colored MP around the sides.  Please note this will tend to cause a more even, constant color.  So if you have some good swirly whirly areas, you may want to dodge them as you work the VERY HOT MP around.  BE VERY CAREFUL.  Make sure to keep your eyes peeled, random globs of VERY HOT MP may gather and fall if you're not paying attention.

• You can avoid the previous tip by just using as little Modge Podge as possible.  I wish I could tell you a perfect MP to food coloring ratio but it's really all trial and error and what sort of look you want.  Dig into your Haunt Hoard of glass jars to experiment with color combinations and MP.  It's endlessly fun.

Finally, like most of my projects that involve candles, I recommend using flameless LED. Safety first and it adds to the longevity of your art.

Share your Fairy Jars in the comments!

311 days till Halloween...

Even and light coating of Modge Podge with
6 drops of yellow food coloring

Swirled and whirled yellow food coloring

4 drops of green, swirled and whirled

Few drops of blue. Mid jar you can see where
the color and MP have begun to mix

Last looks before putting it in the oven

Drum roll...

While not my favorite it's a nice view of how the colors work with Modge Podge - mixing, not mixing, etc.  More results from the craft laboratory below...

Yellow, Green & Red food coloring

Blue & Purple food coloring

Yellow, green, blue & red food coloring

This was my first attempt at the new technique. It's muddled a bit but also pretty cool & will work well in my new prop.

I followed the YouTube video for these, using green & yellow food coloring and pre-mixing it in the Modge Podge

MY BLOODY VALENTINE:

For these bad boys, I premixed the food coloring (red) and MP, put a small amount in the bottom and coated just the lower inch or so.  I then carefully dripped the mixture along the upper rim of the jar, varying quantity for different drip lengths.  I used the same knife I had used for mixing color and MP like a spatula for the drips - scooping up a bit and pouring it gently over the rim.

After it baked for about 15 minutes, I swirled the hot lava MP around the bottom for another coating and also added more drips, laying the color in some places and creating new drips in others.  Repeat this process until you get the color and look you like and finish baking until all the MP is dry.  Bloody great candle holders for Valentine's day...